Alloy Powder For 3d Printing

AlSi10Mg/AlSi10Mg Chemical Composition

Name	Item	Chemical Composition
		Al	Si	Mg	Fe	Cu	Mn	Ni	Zn	Ti	Pb	Sn
AlSi10Mg Content(wt%)	Specification Range	Bal.	9.0-11.0	0.20-0.45	0.55	0.05	0.45	0.05	0.10	0.15	0.05	0.05
	Test Results	.	10.02	0.36	0.056	<0.01	<0.01	<0.01	<0.01	<0.01	<0.03	<0.03
AISi7Mg Content(wt%)	Specification Range	Bal.	65-75	0.45-0.75	0.20	0.10	0.10	0.05	0.10	0.08-0.25	0.05	0.05
	Test Results	·	7.15	0.56	0.08	<0.01	<0.01	<0.01	0.011	0.16	<0.03	<0.03

 

Product Performance Comparison

Name	Specification	Particle Size(μm)			Liquidity (s/50g）	Bulk Density (g/cm³)	Tapped Density (g/cm³)	Oxygen Content (ppm)	Mechanical Properties Of Powder-printed Parts After Annealing
		D10	D50	D90					Yield Strength Mpa	Tensile Strength Mpa	Strain at Break %
AlSi10Mg	20-63	24.12	42.08	67.82	90	1.54	1.73	325	200±20	300±20	20±2
AlSi7Mg	20-63	23.98	43.04	67.71	93	1.44	1.64	516	≥200	≥300	13±2

 

---

316L Stainless Steel Powder

Chemical Composition

Element Content	C	Cr	Ni	Mo	Mn	Si	P	S	Fe
Content	≤0.03%	16 – 18%	10-14%	2-3%	≤2%	≤1%	≤0.045%	≤0.045%	Allowance

Printing Performance

Product Name	Particle Size	Yield Strength	Tensile Strength	Elongation
316L	15－53μm	200±20	500±20	≥35

 

---

3D Printing Aluminium Alloy Powder—AM6013

Product Performance Comparison

Name	Particle Size(μm)	Flowability（s/50g）	Yield Strength Mpa	Tensile Strength Mpa	Elongation%
AM6013	20-63	100±5	450±20	350±20	15-20

Anodizable / High Thermal Conductivity 3d Printed Aluminium Alloy Powder—TAL300

Product Printing Performance

Name	Yield Strength（Mpa）		Tensile Strength(MPa)		Elongation(%)
Condition	As-printed	Heat-treated	As-printed	Heat-treated	As-printed	Heat-treated
Performance	≥200	≥230	≥250	≥280	≥8	≥10

Thermal Conductivity

Serial No.	Temperature(℃)	Thermal conductivity (W/(m.K))
1	25	225
	100	226
2	25	200
	100	210